Comment créer une alarme avec notification sur mobile : Différence entre versions

La valeur fournie «  #include <ESP8266WiFi.h> WiFiClient client;

String MakerIFTTT_Key ;

String MakerIFTTT_Event;

char *append_str(char *here, String s) { int i=0; while (*here++ = s[i]){i++;};return here-1;} char *append_ul(char *here, unsigned long u) { char buf[20]; return append_str(here, ultoa(u, buf, 10));} char post_rqst[256];char *p;char *content_length_here;char *json_start;int compi; int sensor = 13; // Pin D7

void setup() {

 // connect to the wifi
 Serial.begin(9600);
 WiFi.disconnect();
 delay(3000);
 Serial.println("START");
  WiFi.begin("Nom de votre réseau wifi","Mot de passe");
 while ((!(WiFi.status() == WL_CONNECTED))){
   delay(300);
   Serial.print("..");
 }
 Serial.println("Connected");
 Serial.println("Your IP is");
 Serial.println((WiFi.localIP().toString()));
 pinMode(sensor, INPUT); // declare sensor as input
 //   2 minutes to leave home
 pinMode(LED_BUILTIN, OUTPUT);
 digitalWrite(LED_BUILTIN, LOW);   // LED on
 delay(120000);
 digitalWrite(LED_BUILTIN, HIGH);  // LED off

} void loop(){

 long state = digitalRead(sensor); //check sensor value
 if(state == HIGH){  // send an http request to IFTTT if motion detected
     Serial.println("Motion detected!");
     if (client.connect("maker.ifttt.com",80)) {
       MakerIFTTT_Key ="Votre MakerIFTTT_Key";
       MakerIFTTT_Event ="alarme";
       p = post_rqst;
       p = append_str(p, "POST /trigger/");
       p = append_str(p, MakerIFTTT_Event);
       p = append_str(p, "/with/key/");
       p = append_str(p, MakerIFTTT_Key);
       p = append_str(p, " HTTP/1.1\r\n");
       p = append_str(p, "Host: maker.ifttt.com\r\n");
       p = append_str(p, "Content-Type: application/json\r\n");
       p = append_str(p, "Content-Length: ");
       content_length_here = p;
       p = append_str(p, "NN\r\n");
       p = append_str(p, "\r\n");
       json_start = p;
       p = append_str(p, "{\"value1\":\"");
       p = append_str(p, "alarme esp");
       p = append_str(p, "\",\"value2\":\"");
       p = append_str(p, "alarme");
       p = append_str(p, "\",\"value3\":\"");
       p = append_str(p, "");
       p = append_str(p, "\"}");
       compi= strlen(json_start);
       content_length_here[0] = '0' + (compi/10);
       content_length_here[1] = '0' + (compi%10);
       client.print(post_rqst);
 
       Serial.println("request sent");
           delay(600000); //  wait for 10 mns before sending another alert
       }
 }
 else {
 Serial.println("No Motion");
 delay(1000);
     }

} » contient des marqueurs de bande et ne peut donc pas être suffisamment analysée.